The lectures are so boring no one pays attention. The derivations are a mess and she never says the final answer of what we did. She also just starts writing all over the place then erasing. The messiness makes it hard to follow. Just use the textbook. First class I had to read the textbook to understand. Exams were bs though. Midterm was 2 questions. First one had 13 parts to it and they all built off each other. Final was more straightforward but was mostly derivations and no actual solving of problems. Glad it’s over.

The class is basically going through all the concepts and example problems that are SUPER helpful. Those problems most probably come out in the homework. If you go to her class, you will think that it is a little bit boring since she derives the whole thing. BUT, it is fun since you got to know where does the formula comes from and how to use it properly(especially the questions in this course look similar). Other than that, she is very lenient with grading. Make sure you did not leave UNITS in both exam and homework since they will deduct your point for leaving those precious alphabets. TA review session is the-must-go session. Believe me you would not want to miss that session.

Easiest engineering class I've ever taken! I honestly felt like she gave out 50% A+, A & A-
Her homeworks were straight from the book, but the exams are nothing like the homework problems. She spends 1 lecture before the mid term to go over problems that are very similar to the exam questions. If you can understand those, you're golden!

Pros:
clear lectures
straightforward exams
fantastic curve
you're more likely to get an A than to get eaten by a shark

Cons:
sometimes messy equations on board
if you want to learn deeper into this subject, this class isn't for you unless you go to office hours